22 Callibre Cleaner

General Information

Hydro Canada 22 CALLIBRE CLEANER is a clear, low VOC emission, water-thin, solvent cleaner. It is specifically formulated to remove grease, oil, and dirt from the bonding surfaces of PVC, CPVC, ABS, and Styrenepipe and fittings. It is approved for Flowguard Gold CTS plumbing systems.

Application:

Hydro Canada 22 CALLIBRE CLEANER is an all-purpose cleaner and can be used on all sizes, classes, and schedules of PVC, CPVC, ABS, and styrene pipe and fittings. It must be used only as a cleaner in conjunction with the appropriate primer or cement combination. Hydro Canada 22 CALLIBRE CLEANER can also be used as a brush cleaner. Detailed directions on making solvent-cemented joints are printed on the container label. An installation DVD/CD covering solvent cementing is available. It not only describes the basic principle of solvent cementing, but also covers the handling, storage, and use of our products. It is highly recommended that the installer review the instructions supplied by the pipe and fitting manufacturer.

Directions For Use:

Before using this cleaner, pipe and fittings should be cut square, deburred checked for proper fit. Use an applicator (e.g. dauber, brush top applicator, or paintbrush) at least 1/2 the size of the pipe diameter. Do not use a rag as separate contact of cleaner-infused rag with skin may cause irritation or blistering. Apply 22 CALLIBRE CLEANER freely to the socket keeping the surface wet and the applicator wet and in motion for 5-15 seconds. Be sure to use a scrubbing motion to clean off all grease, oil, and dirt. Re-dip if necessary. Avoid pudding the socket.
Apply 22 CALLIBRE CLEANER to the pipe surface in the same manner. Repeat Application to the depth of the socket.
Allow 22 CALLIBRE CLEANER to dry and then apply appropriate Hydro Canda primer or cement following instructions on the cans.

Quality Assurance:

Hydro Canada 22 CALLIBRE CLEANER is carefully evaluated to ensure that consistently high quality is maintained. Fourier transform infrared spectroscopy, gas chromatography, and additional in-depth testing ensure each batch is manufactured to exacting standards. A batch identification code is stamped on each can and assures traceability of all materials and processes used in manufacturing this product. The date code of manufacture is stamped on the bottom of the container. The stability of the product is limited by the evaporation of the solvent when the container is opened and not contaminated. Adding solvent is not recommended and may significantly change the properties of the cleaner.